PM100 Universal Input Module - Discontinued

£190.80
(£159.00 + VAT)

PM100 Universal Input Module - Discontinued

Tap to Enlarge

Click to Enlarge

Discontinued - this product is no longer available.

This innovative universal module for the Formula Sound PM100 Modular Mixer can be configured by small jumpers on the circuit board to accept inputs from low impedance balanced microphone, stereo line and phono (RIAA) input sources.

Each module can be switched between 2 input sources. The possible input selections are: Mic - Phono; Mic - Line; Line - Line; Phono - Line.

INPUT SELECTION
A toggle switch allows rapid selection of the A or B input. Red and Green LEDs provide clear visual indication of the input selected. Adjacent areas are provided to label the input sources.

GAIN
Allows the operator to compensate for variations in programme material.
Rear panel gain trims are also provided to set the maximum gain available on any input.

PEAK
A red led indicates when the peak signal level in the module is just below clipping.

EQUALISATION
3 band eq on all inputs. +6dB boost -20dB cut.
(Special EQ versions available to order allow ranges between +10 and -25dB.)

AUX 2
Push button with led illumination.
The signal in this module is mixed
other source selected. The resulting mix is available at AUX 2 outputs on
module. Can be pre or post fade.

AUX 1
Similar to AUX 2.
A rotary control replaces the switch so that a separate level mix of channels is available at the AUX 1 outputs on the master module. Can be pre or post fade.

BAL/PAN- Stereo balance and pan.
With a stereo source selected this control provides
adjustment to balance stereo signals. With a microphone source selected or the mono switch depressed this control allows the source to be panned anywhere in the stereo image.

PFL- Pre Fade Listen.
Push button with red led illumination. When depressed the signal in this module is connected to the PFL Mix Buss. Any number of channels may be selected simultaneously; the sum of which will be available in the master module for monitoring.

MONO
Push button with red led illumination. When depressed this switch links left and right signals and allows stereo signals to operate in mono.

XFA
Crossfade A select. Depressing the switch routes the channel signal via the
VCA controlled crossfader channel A.

XFB
Crossfade B select. Depressing the switch routes the channel signal via the
VCA controlled crossfader channel B.

Red and green led switch illumination along with similar illumination on the crossfader gives good visual indication of routing status.

FADER
A 60mm studio quality linear fader provided to fade up and down the volume of the channel.

MUTE
Push button with red led illumination. When depressed signal feeds to the programme busses are muted. AUX 1 and AUX 2 are not affected. (Can be disabled if not required).
Factory option - may be rewired to provide low voltage remote start switch via a 3.5mm jack socket on the rear panel.

** Out of stock - this product is no longer available to order **

Rating: Not yet rated

FSD Call 0203 633 0827

Modular Mixers